Node inconsistent configuration Forward Looking Camera (FLC).
شرح
The DTC is set active if one of the following conditions is fulfilled: • a faulty chassis number is sent by the FLC • the CAN message GPM1_FLC has been absent for 15 seconds (time-out) • a chassis number has been sent by FLC, but the DAS vehicle configuration does not include an FLC The DTC is set inactive when none of the above listed conditions are fulfilled. The DTC is not set in the following cases: • ignition is turned off (*) • first 2 seconds after ignition on (*) • system voltage is below 22 volt (*) • system voltage is above 32 volt (*) • communication from FLC node is interrupted (separate DTC) (*) Only used to inhibit DTC for GeneralPurposeMessage time-out.
علت
• The FLC unit is not correctly configured - spare part unit, which has not been programmed/configured - unit transferred from another vehicle • The DAS unit is not correctly configured - spare part unit, which has not been programmed/configured - unit transferred from another vehicle
