Timeout in CAN communication from Steering Angle Sensor (SAS) node
شرح
The DTC is set active if the CAN message SAS_Prop has been absent for 200 ms. The DTC is set inactive when the CAN message SAS_Prop is received. The DTC is not set in the following cases: • ignition is turned off • first 2 seconds after ignition on • system voltage is below 22 volt • system voltage is above 30 volt • short circuit or open circuit on the CAN bus (separate DTCs)
علت
* SAS unit disconnected from the CAN bus * SAS unit has not power supply * Faulty SAS unit
