Forward Looking Camera (FLC) sends invalid values.
شرح
The DTC is set to active if: CAN message GeneralInfoFLCProp:FLCSensorStatus has values 4-13 (reserved) or 15 (not available) for more than 3 seconds. CAN message GeneralInfoFLCProp:FLCSensorStatus has value 1 (Warming up/Initializing) for more than 7 seconds at startup. The DTC is set to inactive if: CAN message GeneralInfoFLCProp:FLCSensorStatus is received and has value within 0-3 or 14. The DTC is not set in the following cases: • Ignition is turned off. • First 2 seconds after ignition on. • System voltage is below 22V • System voltage is above 32V • When the FLC is in init phase. This may last for 10 seconds after ignition on. • When the FLC is performing SPC (single point calibration). This may last for 8 seconds. • When vehicle speed is under 2 km/h.
علت
The Forward Looking Camera (FLC) has an internal fault. There can also be a combination of the following (unknown fault): • FLC reports internal error or misalignment • FLC sends one or more signals with error status. • FLC unit is not correctly connected to the CAN bus or timeout in CAN communication • FLC or DAS unit is not correctly configured - Spare part unit, which has not been programmed/configured - Unit transferred from another vehicle
